#QD2B Straight Pin CC3D Openpilot Open Source Flight Controller

Rp350.000






Straight Pin CC3D Openpilot Open Source Flight Controller 32 Bits Processor
with Black Case
OpenPilot is a next-generation Open Source UAV autopilot. It is a highly
capable platform for multi-rotor craft, helicopters, as well as fixed wing
aircraft. It has been designed from the ground up by a community of passionate
developers from around the globe, with its core design principals being
quality, safety, and ease of use.? Simplicity does not come with any
compromises either: with no hard-coded settings, a complete flight plan
scripting language and other powerful features, OpenPilot is an extremely
capable UAV autopilot platform.

This board is not original CC3D, but it is all the same of CC3D( firmware,
chips...etc.)
The CC3D board is an all-in-one stabilization hardware which runs the
OpenPilot firmware. It can fly any airframe from fixed wing to an octocopter
and is configured and monitored using the OpenPilot Ground Control
Station (GCS) software.

CopterControl from the OpenPilot project introduces a new generation of multi-
purpose aircraft stabilization platforms.

The CC3D has been designed from the ground up to perform the following
functions:
- a MultiRotor controller with auto-level, including TriCopters, QuadCopters
and HexaCopters
- a Flybarless Helicopter controller with auto-level
- a Fixed Wing UAV controller

The CopterControl hardware has the following features:
Powerful STM32 32-bit microcontroller running at 90MIPs with 128KB Flash and
20KB RAM
3-axis high-performance MEMs gyros and 3-axis high-performance MEMs
accelerometer
Tiny 36mmx36mm 4 layer PCB for superior electrical noise reduction and flight
performance.
Software support for Windows, Mac and Linux
Direct high speed USB support with no drivers required, a truly plug and play
device.
Spektrum satellite receiver support
Futaba S-BUS hardware support
Innovative Flexi-port technology for superior port flexibility
4Mbits on-board EEPROM for configuration storage

Manual:
wiki.openpilot.org/display/Doc/CopterControl+Hardware+Manual

Setup Wizard:
wiki.openpilot.org/pages/viewpage.action?pageId=20250682
( 25.4mm =1.00inch)

Package Content:
100% Brand New
1 x CC3D board
1 x CC3D Case
1 x 8pin cable
2 x 4pin cable

Add to Cart:

  • 5 Units in Stock


This product was added to our catalog on Friday 12 February, 2016.

Your IP Address is: 54.80.54.2
Copyright © 2017 MirP Aeromodelling. Powered by Zen Cart