#QD2 APM 2.8 Flight Controller Board with Shock Absorber

Rp750.000  Rp645.000
Save: 14% off






APM 2.8 Flight Controller Board with Shock Absorber

Specification
100% Brand New
This is the new APM 2.8 autopilot module. The sensors are exactly the same as
with APM2.6, however this version does not have an onboard compass, which
makes this version ideal for use with multicopters and rovers.

The APM 2.8 is a complete open source autopilot system and the bestselling
technology that won the prestigious 2012 Outback Challenge UAV competition. It
allows the user to turn any fixed, rotary wing or multirotor vehicle (even
cars and boats) into a fully autonomous vehicle; capable of performing
programmed GPS missions with waypoints. Available with top or side connectors.

This revision of the board has no onboard compass, which is designed for
vehicles (especially multicopters and rovers) where the compass should be
placed as far from power and motor sources as possible to avoid magnetic
interference. (On fixed wing aircraft it's often easier to mount APM far
enough away from the motors and ESCs to avoid magnetic interference, so this
is not as critical, but APM 2.6 gives more flexibility in that positioning and
is a good choice for them, too). This is designed to be used with the 3DR uBlox GPS with Compass (see option below), so that the
GPS/Compass unit can be mounted further from noise sources than APM itself.

Arduino Compatible!
Can be ordered with top entry pins for attaching connectors vertically, or as
side entry pins to slide your connectors in to either end horizontally

Includes 3-axis gyro, accelerometer and magnetometer, along with a
high-performance barometer
Onboard 4 MegaByte Dataflash chip for automatic datalogging
Optional off-board GPS, uBlox LEA-6H module with Compass.
One of the first open source autopilot systems to use Invensense's 6 DoF
Accelerometer/Gyro MPU-6000.
Barometric pressure sensor upgraded to MS5611-01BA03, from Measurement
Specialties.
Atmel's ATMEGA2560 and ATMEGA32U-2 chips for processing and usb functions
respectively.

Package Content
1 x APM2.8 Controller Board with Case
1 x APM2.8 Shock Absorber Conjoined

Add to Cart:

  • 5 Units in Stock


This product was added to our catalog on Friday 12 February, 2016.

Your IP Address is: 54.225.42.99
Copyright © 2017 MirP Aeromodelling. Powered by Zen Cart