#QD2A APM2.6 2.8 Pixhawk Power Module V1.0 Output BEC 5V 3A(XT60

Rp100.000






APM2.6 2.8 Pixhawk Power Module V1.0 Output BEC 5V 3A with XT60 Plug
Power Module is a simple way of providing your APM/Arduflyer with clean power
from a LiPo battery as well as current consumption and battery voltage
measurements, all through a 6P cable. The on-board switching regulator outputs
5.3V and a maximum of 3A from up to a 7S LiPo battery.Special for
APM2.5.2 APM2.6 Pixhawk flight controller
Note: The Power Module is only designed to power APM/Arduflyer, a RC receiver and
accessories (GPS, Radio telemetry). It is not designed to power servos.
Use your aircraft's own ESC/BEC for that.

Features:
- XT60 Plug
- Max input voltage: 30V
- Max current sensing: 90A
- Voltage and current measurement configured for 5V ADC
- Switching regulator outputs 5.3V and 3A max
- 6P molex cable plugs directly to APM/Arduflyer 2.5's 'PM' connector

Specifications:
- Dimension(mm): 25 x 21 x 9
- Weight(g): 17(include all wire)
v Packing Content:
- Power Module V1.0 Output BEC 5V 3A with XT60 Plug for APM 2.6 2.8 Pixhawk

Add to Cart:

  • 10 Units in Stock


This product was added to our catalog on Thursday 20 July, 2017.

Your IP Address is: 54.224.216.155
Copyright © 2018 MirP Aeromodelling. Powered by Zen Cart