#E018 Turnigy 5A 1S Brushless ESC


Turnigy 5A-1S ESC a very small and light brushless speed controller which
supports 1S (3.7-4.2v) lipo cell with built-in 0.5A/5v BEC
output. Perfect for micro-heli and indoor flyers.

Microprocessor controlled
Extremely low resistance
3A continous(5A surge)
1S lipo cell or 3 cell NiMH/NiCAD
High rate adjustable switching (PWM:8KHz/12KHz/16KHz)
BEC: Max 0.5A (switching)
Low Voltage Cutoff: 3.0v
Programmable cutoff types(soft cutoff/hard cutoff)
Programmable brake type(disable/soft brake/hard brake)
Time advance programmable (low/standard/high)
Programmable current limiting(very ensitive/standard/insensitive/disable)
Programmable startup type(very soft start/soft start/fast start)
Thermal Protection(100 centigrade)
Apply to most of inrunner and outrunner brushless motors.
Safe power on arming program ensures motor will not accidentally turn on.
Auto shut down when signal is lost or radio interference becomes severe
for more than 3 seconds .After radio connection has been
reestablished, moving the throttle to the lowest position can restart
the motor.

Note: Programable with Turnigy monster programing card.

voltage: 3.0~4.2V
Cont. Current: 3A
Burst Current: 5A
Battery: 1 Cell Lipo / 3 cell Nixx
BEC: 5V/0.5A
Size: 25*13*5mm
Weight: 2g

We suggest customers to not program the esc with their Tx.

Add to Cart:

  • 2 Units in Stock

This product was added to our catalog on Wednesday 21 November, 2012.

Your IP Address is:
Copyright © 2022 MirP Aeromodelling. Powered by Zen Cart